OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P283D

Shift Fork C Position Circuit Low

P283D reports the fork C input stuck low. In the Corvette dual-clutch gearbox GM feeds the rod 3 sensor from reference B rather than reference A, so its enable test watches that second 5 V rail and pauses while P0652 or P0653 are present. Within those limits the code sets after 150 ms if no pulses are seen and the pin stays below 2.0 V, or if the duty cycle falls under 8 %; it is classed Type A. For rod sensor 3 of the TR9070, Ford reports a zero-stuck input whose pulse width falls short of the window. Mercedes-Benz interprets P283D00 on the 8G-DCT as a fork C sensor shorted to ground. Because rods 3 and 4 share reference B on the Corvette, a supply fault there would also disturb fork D.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 3D

Possible causes

  • Fork C signal line shorted to ground in the gearbox harness high
  • Fork C sensor no longer switching its output medium
  • Damaged supply wire from reference B to the sensor low

Symptoms

  • Limp-home mode with warning lamp
  • Gears of fork C unavailable
  • Possibly further fork D codes if the shared supply is affected

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P283D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication