P283B
Shift Fork C Position Circuit
P283B is the generic circuit code for the shift fork C position sensor. The only public manufacturer listing that uses it comes from Mercedes-Benz: on the 8G-DCT dual-clutch transmission (724.1) P283B00 stands for an electrical fault of the fork C sensor and belongs to the codes covered by its XENTRY repair routine for this gearbox. GM's Corvette software, in which fork C is rod 3 on the even-gear shaft, and Ford's TR9070, which calls it rod position sensor 3, do not set P283B and break circuit faults down into P283D, P283E and P283F instead. Ford's 2012 DPS6 has just two shift drums and no fork C code. Once the reading is lost, the gears this fork engages are normally dropped and the transmission continues in a fallback mode.
Possible causes
- Fork C position sensor with an internal electrical fault high
- Poor contact or moisture at the sensor or TCM connector medium
- Damaged sensor input in the transmission control module low
Symptoms
- Transmission warning in the instrument cluster
- Gears handled by fork C no longer engaged
- Emergency mode with reduced performance
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P283B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.