OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2839

Shift Fork B Position Circuit High

P2839 covers the other end of the scale: the fork B input is pinned high. GM's 2023 Corvette table for rod 2 sets it when pulses stop and the pin carries more than 3.5 V, or once the duty cycle passes 92 %. The test runs all the time except during cranking, and only while system voltage lies between 8.75 and 18 V and reference A between 4.5 and 5.5 V; 150 ms of the condition produce a Type A code. Ford's TR9070 lists P2839 for rod sensor 2 when the pulse width climbs above its window and the input stays at one, and on the 8G-DCT Mercedes-Benz reserves it for a fork B sensor with a short to battery positive. Check the harness for a signal wire rubbing against a supply line and confirm the sensor ground before replacing the sensor or module.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 39

Possible causes

  • Signal wire of the fork B sensor touching the 5 V or battery supply high
  • Open sensor ground letting the output float high medium
  • Sensor output stage stuck in the high state low

Symptoms

  • Warning lamp and fault message in the cluster
  • Fork B gears blocked, fewer gears available
  • Reduced acceleration in the substitute program

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2839

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication