P2838
Shift Fork B Position Circuit Low
P2838 is stored when the fork B position input reads at the bottom of its range. The Corvette's rod 2 sensor, fed by GM from the same 5 V reference A as rod 1, has to send a pulse-width signal; if pulses are missing while the pin is below 2.0 V, or the duty cycle drops under 8 %, the module waits 150 ms and logs a Type A fault. Faults of reference A itself (P0642, P0643) suspend this test, so a supply problem shows up under those codes and tends to hit rod 1 as well. Ford's TR9070 summary describes the pattern for rod sensor 2 as a pulse width below its window with the input stuck at zero. Mercedes-Benz reads P283800 on the 8G-DCT as a fork B sensor shorted to ground. Gears on that rod are then locked out.
Possible causes
- Fork B sensor signal wire chafed through to ground high
- Sensor output no longer producing pulses medium
- Break in the signal or supply wire leaving the input low low
Symptoms
- Warning lamp with transmission in limp-home mode
- Gears on rod 2 or fork B no longer selected
- Rough or delayed shifts around the locked-out gears
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2838
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.