OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2834

Shift Fork A Position Circuit High

P2834 is the high-side counterpart: the fork A position input sits at the upper limit. In GM's 2023 Corvette table the rod 1 sensor is flagged when pulses stop and the pin voltage stays above 3.5 V, or when the duty cycle climbs over 92 %; after 150 ms a Type A fault is stored, but only while the sensor supply lies between 4.5 and 5.5 V and the battery between 8.75 and 18 V. Ford's 2024 summary for the TR9070 describes the same condition as pulse width above its window, input stuck at one. On the Mercedes-Benz 8G-DCT the code means the fork A sensor circuit has shorted to positive. A signal wire touching the sensor supply or a sensor whose output transistor no longer switches are the usual explanations.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 34

Possible causes

  • Signal wire shorted to the 5 V sensor supply or battery voltage high
  • Sensor output transistor no longer pulling low medium
  • Lost sensor ground low

Symptoms

  • Warning lamp with stored code
  • Shifts on the affected shaft blocked
  • Reduced driveability in limp-home mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2834

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication