OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2833

Shift Fork A Position Circuit Low

P2833 reports a fork A position signal stuck at the low end. On the Corvette dual-clutch gearbox the rod 1 sensor sends a pulse-width signal; GM's 2023 table sets the code when no pulses arrive and the pin stays under 2.0 V, or when the duty cycle drops below 8 %, each confirmed for 150 ms, with the 5 V sensor supply in range and rated Type A. Ford's 2024 summary calls the same case on the TR9070 a pulse width below its window, input stuck at zero. Mercedes-Benz uses P283300 when the fork A sensor circuit is shorted to ground in the 8G-DCT. Because a supply fault can mimic this pattern, GM blocks the test while supply codes such as P0642 are present. The gearbox then can no longer place the gears on that rod reliably.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 33

Possible causes

  • Signal wire of the fork A sensor shorted to ground high
  • Sensor output stage failed low medium
  • Open signal line letting the input float low low

Symptoms

  • Warning lamp and limp-home mode
  • Gears of one shaft locked out
  • Car may only pull away in a fallback gear

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2833

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication