OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2830

Pressure Control Solenoid K Control Circuit High

P2830 is set when the K control line carries voltage where the switched-on low-side driver should pull it down. GM applies it to the selector pilot valve of the 2023 Corvette dual-clutch box with a limit that climbs as supply voltage increases, from about 0.7 V below 11.5 V to 1.1 V above 15.5 V, confirmed after 100 ms. The same code also records a current estimate that misses the target by more than 70 % for 60 ms or by 400 mA over 300 ms; a short to an adjacent output, which a shutdown test writes to memory, is reported at the next start as well. Every variant is rated Type A, unlike the Type B rating of the park lock valve J. Ford's TR9070 lists a shorted load at its selector pilot valve as P27E0. Look for wires rubbing on supply lines and for moisture in connectors.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 30

Possible causes

  • Control wire shorted to a supply line high
  • Short to an adjacent solenoid output medium
  • Moisture in the connector medium

Symptoms

  • Gear preselection fails, limp mode
  • Code back immediately after restart
  • MIL on

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2830

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication