P282F
Pressure Control Solenoid K Control Circuit Low
P282F reports a ground fault on the control line of solenoid K. On the 2023 Corvette, GM checks the selector pilot valve while its low-side output is switched on; the TCM compares the voltage at the sense pin with a lower limit of about 1.7 V, and a reading below it points to a ground short. After 100 ms the module stores a Type A code, so the MIL lights during the same trip. Battery voltage has to lie between 8.75 and 18 V and the engine must not be cranking. Ford's TR9070 summary uses P27DF for a shorted switch at its own selector pilot valve instead. Expect gears on one clutch shaft to be blocked; chafed insulation inside the transmission harness is the first thing to look for.
Possible causes
- Control wire to valve K shorted to ground high
- Damaged insulation inside the transmission harness medium
- Coil of valve K shorted to ground internally low
Symptoms
- Gears on one clutch shaft blocked
- MIL on in the same trip
- Limp mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P282F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.