OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P282D

Pressure Control Solenoid K Control Circuit/Open

P282D marks an open control circuit of solenoid K. GM's 2023 Corvette dual-clutch software applies it to the selector pilot valve. With the low-side output off, a connected coil would pull the sense pin up to battery voltage; the driver instead attempts to keep the pin near ground using a very small current, and if the voltage settles between roughly 1.7 and 3 V the load is considered missing. Once 100 ms of confirmation have passed, the TCM logs a Type A fault and lights the MIL in the same drive. The test only runs between about 8.75 and 18 V and not during cranking. Ford's TR9070 reports an open selector pilot valve as P27DD rather than under K. Broken wires, a pushed-back terminal or an open coil leave the selector unable to switch between shift rods.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 2D

Possible causes

  • Broken wire to the selector pilot valve high
  • Terminal pushed back in the connector medium
  • Open coil in solenoid K medium

Symptoms

  • Gears on one shaft unavailable
  • MIL on immediately
  • Limp mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P282D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication