P282A
Pressure Control Solenoid K Stuck On
P282A reports the reverse of P2829: K holds the selector mechanism in its pressurized state after being switched off. GM's 2023 Corvette dual-clutch software uses the same synchronizer integrity routine, this time with a test case whose selector target is hydraulic off. When the measured rod motion matches the on position and the selector pilot valve's current profile check keeps failing, the TCM blames the pilot valve rather than the selector spool and stores a Type A fault. Ford's TR9070 summary lists the matching stuck-on case for its selector pilot valve as P27DA. A pilot valve hanging open may route pressure to the wrong shift rod, so the controller can lock out gears or choose a limp mode. Dirty fluid and worn valve bores are the usual mechanical reasons.
Possible causes
- Selector pilot valve stuck in the applied position high
- Worn valve bore causing internal leakage medium
- Contaminated fluid jamming the valve medium
Symptoms
- Gears locked out or limp mode
- Clunk or unexpected rod movement during shifts
- MIL on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P282A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.