OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2826

Pressure Control Solenoid J Control Circuit Low

P2826 indicates that the line to solenoid J is pulled to ground. GM's 2020 tables name three uses for J: the clutch select valve of the nine-speed, the default disable valve of the ten-speed and the boost valve of the eight-speed. About 0.5 ohm to ground for 0.3 of 0.5 s gives a Type A fault, and T87a eight-speed controllers also log P2826 when the J circuit is open, so a broken wire can hide behind it. The 2016 eight-speed table already set it after one trip with the same window. On the 2023 Corvette the park lock engaging valve is checked while energized; a pin voltage below roughly 1.7 V for 150 ms yields Type B. Ford's TR9070 assigns a shorted switch at its park lock valve to this code. Chafed insulation at brackets is a frequent cause.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 26

Possible causes

  • Control wire shorted to ground through chafed insulation high
  • Coil of valve J shorted to its housing medium
  • Open J circuit reported as low on GM T87a controllers low

Symptoms

  • Limp gear or loss of boost pressure
  • Park lock fault message (dual-clutch models)
  • MIL on

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2826

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication