P2824
Pressure Control Solenoid J Control Circuit/Open
P2824 reports an open in the control line of solenoid J. GM's 2016 table for T87 eight-speed controllers uses J for the on/off boost valve of clutch 2 and flags the code in one trip once the fault persists 0.3 s within a half-second sample. In the 2020 tables the code is limited to T93 ten-speed controllers, where J is the default disable valve, and an impedance near 200 kilohm between signal and ground leads to Type A. The 2023 Corvette dual-clutch box tests its park lock engaging valve while switched off: if the pin can be held between about 1.7 and 3 V with a tiny current, no load is connected, and after 150 ms a Type B code is set. Ford's TR9070 files an open park lock valve here. Broken wires, backed-out terminals or an open coil are typical.
Possible causes
- Broken wire between TCM and valve J high
- Terminal pushed back or not latched in the connector medium
- Open coil in solenoid J medium
- Faulty output driver in the TCM low
Symptoms
- Hydraulic limp gear or no shifting
- Park lock cannot be operated (dual-clutch models)
- MIL on after one or two trips
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2824
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.