OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2822

Pressure Control Solenoid J Electrical

P2822 gathers electrical faults of solenoid J without saying whether the circuit is open or shorted; a failure-type byte adds that detail. Mercedes-Benz uses the code on two gearboxes, and in both J is pressure regulating valve 9. For the 9G-Tronic (transmission 725.0), information LI27.60-P-064292 reports P282212, a short to positive at valve 9, together with P060C00 on new C-, E- and S-Class cars (series 205, 213, 222) as they leave transport mode; there the fix is to let the car sleep and then clear the memory, while the note stresses that real faults remain possible. On the 8G-DCT, P282200 is part of the IPR guided test. GM splits J wiring faults into P2824, P2826 and P2827. Start with coil resistance and the gearbox connector.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 22

Possible causes

  • Short to positive in the valve J circuit medium
  • Signal timing when leaving transport mode on new vehicles (Mercedes 9G-Tronic) medium
  • Open or shorted coil of valve J medium
  • Corrosion or loose pins at the transmission connector low

Symptoms

  • Transmission warning or MIL
  • Emergency mode with fixed gear
  • Code present on a new car without driveability complaint

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2822

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication