P281E
Pressure Control Solenoid H Control Circuit High
P281E sets when the line to solenoid H carries supply voltage where the module expects the load to pull it down. GM's 2020 tables cover the converter clutch valve on nine- and ten-speed automatics and the default valve on the eight-speed with the same timing as the low code: 0.3 s within 0.5 s, Type A, one trip. On the 2023 Corvette dual-clutch gearbox the threshold for the shutdown valve of the differential lock rises with battery voltage, from about 0.7 V to 1.1 V at the pin. The same code also covers a valve current that strays from its target and a short to a neighbouring output, which the shutdown test detects and saves, so P281E can appear right after a restart. Look for pinched wires next to supply lines and for water in connectors.
Possible causes
- Control wire of solenoid H shorted to a voltage source high
- Moisture in the transmission connector bridging pins medium
- Short between solenoid H and a neighbouring output low
Symptoms
- MIL on, possibly right after starting
- Converter clutch or differential lock function lost
- Firm shifts in a substitute program
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P281E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.