OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P281D

Pressure Control Solenoid H Control Circuit Low

P281D signals that the control line of solenoid H is shorted to ground. In GM's 2016 eight-speed table H is the on/off default valve; the low flag must persist for 0.3 s within 0.5 s and one trip lights the MIL. The 2020 tables extend this to the nine- and ten-speed converter clutch valve, using about 0.5 ohm to ground as the limit and rating it Type A, and add that T87a eight-speed controllers also report an open default valve circuit as P281D, so an interrupted wire can hide behind this code. On the 2023 Corvette dual-clutch box the redundant shutdown valve of the differential is checked while switched on; a voltage below about 1.7 V at the output pin is held for 150 ms before the Type B code is stored.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 1D

Possible causes

  • Control wire of solenoid H shorted to ground high
  • Open default valve circuit reported as low (GM T87a eight-speed) medium
  • Coil insulation failure inside solenoid H medium

Symptoms

  • MIL on after a single trip
  • Transmission in default gear or fixed pressure mode
  • Converter lockup or differential lock unavailable

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P281D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication