OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P281C

Pressure Control Solenoid H Control Circuit Range/Performance

P281C is meant for a circuit of solenoid H that is electrically intact but does not behave plausibly, for example when the measured current fails to follow the commanded value. No manufacturer documents this code publicly; CARB 13 CCR 1968.2 only demands functional monitoring of output circuits. GM's 2023 Corvette dual-clutch software does run exactly such a test on its H valve, comparing the current estimated from duty cycle and battery voltage with the target, but files a deviation of over 70 % or 200 mA under the high-side code P281E. On the G side, Nissan-built CVTs use the matching code P2813 mainly for a hydraulic engagement fault. If P281C appears, check coil resistance against specification and look for high contact resistance.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 1C

Possible causes

  • Coil resistance of valve H outside specification high
  • Corroded or loose contacts raising circuit resistance medium
  • Unstable supply voltage to the solenoid driver low

Symptoms

  • MIL or transmission warning on
  • Shift quality varies from drive to drive
  • Possible substitute program

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P281C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication