P281A
Pressure Control Solenoid H Intermittent
P281A marks a fault at valve H that comes and goes, either electrically or in its hydraulic effect. There is no public manufacturer description of P281A. CARB 13 CCR 1968.2 calls for monitoring of such actuators but does not prescribe an intermittent code. GM's 2020 tables show why short dropouts are hard to catch: the H circuit codes P281B, P281D and P281E only set when a fault flag stays active for at least 0.3 of every 0.5 s, so a contact that opens for a few milliseconds may only show up as a rough shift. Typical places for such faults are loose terminals at the gearbox connector, cracked solder joints in a mechatronic unit and coils that fail only when hot. Freeze-frame data and a wiggle test with live data help more than a single resistance check.
Possible causes
- Loose or corroded terminal at the transmission connector high
- Coil of valve H failing only at operating temperature medium
- Cracked solder joint in an integrated mechatronic unit low
Symptoms
- Occasional harsh or delayed shift
- Warning lamp that comes and goes
- Short spells of limp-home mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P281A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.