OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2818

Pressure Control Solenoid H Stuck On

P2818 reports that valve H stays effective when it should be released. In GM's eight-speed table for the 8L90, H is the default valve: in Park at 400-900 rpm, with fluid between 0 and 40 °C and a converter clutch test pressure of 600 kPa, slip of 6 rpm or less for 0.5 s counts as a fail, and the MIL follows after two trips. Bulletin PI1405 repeats cold starts in that range and replaces the gearbox if the code returns; 15-07-30-002 instead reprograms the module against firm 1-2 and 3-1 shifts with P0606 or P2818. On the ten-speed H is the converter clutch valve; GM bulletin 24-NA-230 links a stuck-on clutch on 2024-2025 Silverado and Sierra 1500 to the engine stalling when D or R is selected, mostly due to the valve body.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 18

Possible causes

  • Valve in the valve body sticking in the applied position high
  • Early TCM calibration (GM 8L90 2015, reprogramming) medium
  • Internal transmission fault that persists when cold (PI1405) medium
  • Contaminated fluid holding the valve low

Symptoms

  • Engine stalls when coming to a stop or when D or R is selected
  • Firm upshifts or downshifts, shudder
  • MIL on, code may set only at low fluid temperature

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2818

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication