OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2817

Pressure Control Solenoid H Performance/Stuck Off

P2817 means valve H fails to produce the effect it is commanded to give. On GM nine- and ten-speed automatics H is the converter clutch valve: too much slip in lock mode (130 rpm) or a large slip error in controlled mode, counted three times, sets a Type A fault. GM's PIP6005 traces the code on 2024-2025 Enclave, Traverse and Acadia with the 8T65 to a seal on the turbine shaft that was harmed when the converter went in; torque converter and seal are replaced. Honda calls H the O/P shift solenoid of its CVT: bulletin 19-047 covers 2016-2018 Civic 1.5 L, 2017-2018 CR-V and some 2018-2019 Accord, where the module misread drive pulley pressure as too high, and new software fixes it. The flashing D lamp, converter slip or poor fuel economy follow. P2818 is the reverse fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 17

Possible causes

  • Valve H stuck or hydraulically unable to apply high
  • Damaged turbine shaft seal letting converter clutch pressure escape (GM 8T65) medium
  • Misjudged pressure signal in older control software (Honda CVT) medium
  • Low or degraded transmission fluid low

Symptoms

  • MIL on or flashing D indicator
  • Converter clutch slips, engine speed higher than usual at cruise
  • Increased fuel consumption

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2817

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication