OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2815

Pressure Control Solenoid G Control Circuit High

P2815 is the opposite electrical case: the driver of solenoid G sees battery voltage where the load should pull the pin down. In GM's 2016 eight-speed table, where G is the converter clutch pressure valve, the flag must stand for 0.3 s of a 0.5 s window and one trip is enough. The 2023 Corvette dual-clutch software, with G as the limited-slip valve, also books two further checks here: estimated current deviating from target by over 70 % for 60 ms or by 200 mA for 300 ms, and a short to a neighbouring output found during the shutdown test and set at the next start, rated Type B. Ford lists a shorted load on the TR9070 even clutch cooling valve under this code. Check the harness for contact with a supply wire before replacing parts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 15

Possible causes

  • Control wire of solenoid G touching a supply voltage wire high
  • Solenoid coil with shorted turns drawing too much current medium
  • Two solenoid outputs shorted together inside the harness or valve body low
  • Faulty driver stage in the transmission module low

Symptoms

  • MIL lit and transmission in a substitute program
  • Harsh engagement or missing converter lockup
  • Code may appear only after the next engine start (shutdown test)

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2815

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication