OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2814

Pressure Control Solenoid G Control Circuit Low

P2814 reports that the drive line of solenoid G is pulled toward ground, typically a chafed wire or a coil shorted to ground. GM's 2020 tables name G as the line pressure valve on nine- and ten-speed boxes and the converter clutch valve on the eight-speed; a resistance of about 0.5 ohm to ground, present for 0.3 s out of a 0.5 s sample, sets a Type A fault. In the 2023 Corvette dual-clutch box G drives the limited-slip differential, and a pin voltage under roughly 1.7 V while switched on stores it as Type B. Ford's 2024 summary uses it for a shorted switch on the even clutch cooling valve of the TR9070. GM's PIP5799 replaces the 10-speed valve body when P2812 or P2814 has no other cause. Expect firm shifts or a fixed line pressure.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 14

Possible causes

  • Solenoid G control wire chafed through to ground in the gearbox harness high
  • Solenoid G coil with internal short to its housing medium
  • Fault inside the valve body assembly (GM 10-speed, PIP5799) medium
  • Damaged output stage in the transmission control module low

Symptoms

  • MIL or transmission warning on, often with a fault message
  • Firm shifts because line pressure falls back to a fixed value
  • Converter clutch no longer locks up (eight-speed applications)
  • Limited-slip differential inactive on dual-clutch Corvettes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2814

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication