OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2813

Pressure Control Solenoid G Control Circuit Range/Performance

On paper P2813 is a plausibility fault in the control circuit of solenoid G, but its main real-world use is hydraulic. Nissan-built CVTs label it as the select solenoid, which applies the forward and reverse clutches. Mitsubishi's 2022 service data for such a CVT sets it in two ways: engagement after N to D or to R happens too fast, under 0.4 s or 0.3 s with input speed at 200 rpm or less, three times in one drive cycle; or the clutch slips with 0.95 MPa commanded, adding up to 30 s. The MIL follows after two trips. Nissan bulletin NTB16-110 covers it on four-cylinder Altima (2013-2017) and Rogue (2014-2017) together with judder codes and replaces the valve body or a CVT section. Expect engagement shock or a sluggish start.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 13

Possible causes

  • Select solenoid valve sticking in the valve body high
  • CVT wear with belt slip or clutch damage medium
  • Degraded or contaminated CVT fluid medium
  • Added resistance in the solenoid circuit low

Symptoms

  • Strong shock when selecting D or R
  • Slow start and weak acceleration
  • MIL after the second trip

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2813

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication