Powertrain
generic / SAE
P2812
Pressure Control Solenoid G Control Circuit/Open
The TCM detects an open circuit in the control wiring of pressure control solenoid G. No current flows when the solenoid is commanded.
SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 12
Possible causes
- Open in solenoid control wire high
- Open solenoid coil medium
- Pin pushed back out of connector body low
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 200–1800 €
- Estimated time: 1.5–6 h
- Component: pressure control solenoid g
- Component: wiring harness
- MIL / check engine light
- limp mode possible
Sources
References
sae:J2012