OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P280B

Transmission Range Sensor B Circuit Not Learned

P280B flags missing or invalid adaptation values for the second range sensor signal. Where a design reads A and B in different modules, as GM does with sensor A in the TCM and sensor B in the engine module, a replaced or reprogrammed engine controller can lose the B reference while A is still learned. No maker documents P280B publicly, and CARB 13 CCR 1968.2 gives only the general duty to monitor transmission inputs. GM's correlation check P2805 shows how closely both paths are compared afterwards: their duty cycles must add up to 100 % within about 5 %. Without a valid B reference the plausibility checks against A cannot run. Perform the learn with a scan tool once circuit codes P2800-P2804 are cleared.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 0B

Possible causes

  • Module reading sensor B replaced or reprogrammed without learn high
  • Learn procedure interrupted medium
  • Open circuit faults on sensor B preventing the learn low

Symptoms

  • Warning lamp after module replacement
  • Gear position checks disabled, possible start refusal

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P280B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication