P2809
Pressure Control Solenoid G Stuck On
P2809 is the reverse case: valve G keeps acting although it should have released. On GM's 2016 eight-speed automatics, where G operates the converter lockup clutch, the converter shows almost no slip, between minus 50 and plus 30 rpm, while the clutch is commanded off; after 1.5 s and six fail counts the controller stores the code, with the MIL lit in the first trip. GM's 2023 Corvette dual-clutch table uses the same code when the differential lock valve stays hydraulically engaged, found during a recovery routine and logged as Type B. A converter clutch that does not release can stall the engine when stopping or make the car shudder at low speed. Contaminated fluid and a sticking valve are the leading suspects.
Possible causes
- Valve G held open by debris high
- Contaminated or degraded transmission fluid medium
- Mechanical fault inside solenoid G low
Symptoms
- Engine stalls or shudders when coming to a stop
- MIL on
- Differential stays locked on Corvette, tyre scrub in tight turns
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2809
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.