OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2808

Pressure Control Solenoid G Performance/Stuck Off

P2808 means valve G does not deliver the pressure or effect it is commanded to give. GM documents two very different applications. In the 2016 eight-speed table G is the converter clutch valve: with at least 750 kPa commanded, slip of 130 rpm or more in lock mode for 4 s, counted three times, sets the code, and the MIL needs two trips. In the 2023 table for the Corvette dual-clutch gearbox, G is the proportional valve of the electronic limited-slip differential; after a fault triggers a recovery routine, failed current profile checks show the valve hydraulically stuck off, logged as Type B. For the driver this means converter slip and higher fuel use, or a differential that no longer locks. The opposite fault is P2809.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 08

Possible causes

  • Valve G stuck by contamination so pressure stays low high
  • Worn converter clutch lining that slips despite pressure medium
  • Low fluid level or internal leak in the circuit medium

Symptoms

  • MIL on, engine speed higher than expected at cruise
  • Higher fuel consumption and transmission heat
  • Limited-slip function inactive on Corvette

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2808

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication