P2807
Pressure Control Solenoid G
P2807 is the umbrella code for pressure control solenoid G; the fault type follows in the extra byte. Which hydraulic function G controls is set by each maker. Toyota uses it on its eight-speed automatics: bulletin T-SB-0160-18 lists P28077F (actuator stuck off) on 2017-2018 Highlander and Sienna together with other solenoid codes, whine, harsh shifts and reduced power, and supplies a remanufactured transaxle. T-SB-0076-24 for the 2024 Tacoma names P280771 (actuator stuck) and replaces gearbox and converter. GM's 2016 eight-speed table assigns G to the converter clutch. Specific sibling codes are P2808 to P2815. Debris in the valve body is the usual root cause, so fluid analysis comes first.
Possible causes
- Debris or wear particles jamming the valve high
- Internal transmission damage producing particles medium
- Solenoid G worn or electrically weak medium
Symptoms
- MIL on with harsh or delayed shifts
- Whine noise from the transmission
- Reduced power or limp mode
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2807
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.