P2806
Transmission Range Sensor Alignment
P2806 says that the selector position reported by the range sensor and the actual mechanical position of the gearbox do not line up. Ford is the only public user found. Its 2019 hybrid OBD summary lists the code for the eCVT with the wrench lamp and without the MIL; one section defines a park pawl check behind it: if the park motor turns more than 9 radians while the pawl should already be engaged, the code is set. Another section for the same family checks sensor voltages against fixed windows for each position. Common causes are a sensor moved on its shaft after service, a worn selector cable or linkage, or a damaged park mechanism. Re-adjust or replace the sensor and confirm Park holds before driving.
Possible causes
- Range sensor not aligned correctly after transmission work high
- Stretched selector cable or worn linkage medium
- Park pawl or park motor mechanism damaged medium
Symptoms
- Wrench lamp, gear display differs from lever position
- Vehicle may roll in Park
- Start refused in Park or Neutral
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2806
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.