OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2805

Transmission Range Sensor A/B Correlation

Both range sensor signals are valid on their own, yet they do not agree. Many designs output two complementary pulse-width signals whose duty cycles must add up to 100 %. GM reads signal A in the transmission module and signal B in the engine module and sets P2805 as Type A when the sum is off by more than 4.849 % (2020 table) or 5.2 % (2025) for 1 s of 1.5 s. Ford allows plus or minus 4 % on its six- and ten-speed automatics (2024) and used the same principle on the DPS6 (2012). Audi bulletin 2051686 for 2016-2017 A6 links P280500 with a no-start and a gearbox message, cured by a new drive position sensor G676 plus TCM. Single-signal faults are P0705-P0709 and P2800-P2804.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 05

Possible causes

  • Range sensor with one drifting output high
  • Added resistance or poor ground in one of the two signal paths medium
  • Fault in the reading control module low

Symptoms

  • MIL and gearbox warning on
  • Engine will not start or selector position not accepted
  • Substitute gear or limp operation

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2805

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication