OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2803

Transmission Range Sensor B Circuit High

P2803 is stored when the output of range sensor B reads too high, which typically points to an open circuit or a short to supply voltage. In GM's 2020 and 2025 tables the engine module watches its own range sensor input for this: either under 0.5 ohm to the voltage source or above 200 kilohms to ground for 0.5 s sets a Type A fault. Ford's 2024 summary flags a duty cycle over 92 % (P2800_85). In practice Ford saw P2803 together with P2804 and fluid temperature codes on 2020-2021 Transit vans, where partly seated or damaged pins in four connectors were to blame (SSM 49242 and 49510). On 2021 Bronco Sport, bulletin 21-2331 tied it to PCM calibration and fixed it by reprogramming. Low is P2802.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 03

Possible causes

  • Open signal circuit or pushed-out connector pin high
  • Signal wire shorted to a voltage source medium
  • Module calibration misreading the signal, fixed by software low
  • Range sensor output stuck high low

Symptoms

  • MIL on, often with transmission temperature codes
  • Shift system warning in the instrument cluster
  • Wrong or missing gear display

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2803

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication