P2801
Transmission Range Sensor B Circuit Range/Performance
Here the B signal of the range sensor is electrically present but its content does not make sense. On sensors with a pulse-width output, Ford checks the carrier frequency: its 2024 summary sets P2801 (UDS P2800_38) on the 6R80, 6R140, 10R60 and 10R80 automatics when the frequency leaves 125 Hz plus or minus 25 Hz, while the 2012 summary applies the same test to the 250 Hz signal of the DPS6 dual-clutch box. On the hybrid eCVT, Ford's 2019 summary instead compares two sensor angles and fails it beyond 3.85 degrees, with the wrench lamp only. Ford SSM 49822 lists P2801 among range and fluid temperature sensor codes on 2020-2021 Super Duty trucks with the 10R140. P0706 is the A-side counterpart.
Possible causes
- Range sensor electronics producing a wrong signal frequency high
- Damaged or loose pins at the transmission connector medium
- Sensor shifted on its shaft so the angles disagree low
Symptoms
- Warning lamp with shift quality or gear display issues
- Transmission uses a fixed substitute range strategy
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2801
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.