P27F5
Gear Shift Lock Solenoid/Actuator A Stuck Off
With P27F5 the control unit concludes that shift lock actuator A remains in its passive state although it was told to act. Depending on the design, that can leave the lever free to leave Park without the brake, which defeats the brake interlock, or permanently blocked. No maker publishes this code. FCA recall 16V-249 describes a badly crimped harness terminal on the interlock solenoid of 2016 Jeep Grand Cherokee that cut solenoid function. Ford reports a shift lock actuator that misses its target position as P0929 and fixes it with a new module or software (SSM 51057). Typical culprits are a loose terminal, a weak coil or a broken return spring. P27F4 covers the actuator stuck in its active state; wiring faults are P0928 to P0931.
Possible causes
- Loose or badly crimped terminal at the lock solenoid high
- Weak solenoid coil that no longer moves the lock pin medium
- Broken return spring or worn lock pin low
- Shifter module software misjudging the actuator position low
Symptoms
- Selector leaves Park without the brake pedal being pressed
- Lever stays blocked in Park or Neutral
- Shift system warning message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27F5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.