P27F2
Transmission Range Control B Position Sensor/Switch Circuit High
With P27F2 the TCM sees the valve B position sensor above its valid range, which GM interprets as a short to voltage on that circuit. The threshold is 2.538 V, which must persist 0.100 s in a 0.163 s sampling period; GM applies it to internal range selection in the 2018 T87A nine-speed and the 2020 rear-drive ten-speed. The 2020 table rates it Type A; in the 2018 edition the MIL entry for P27F2 is blank. With valve B unconfirmed, GM suspends the movement test P27F0. Apart from a real short, a lost sensor ground can push the reading up, so measure the ground before replacing parts. P27EE is the same fault on valve A, P27F1 the low reading and P27EF the illegal mid-band level. Shifting into neutral or drive may be restricted.
Possible causes
- Valve B sensor line shorted to a voltage source high
- Sensor ground interrupted medium
- Hall sensor B electronics faulty low
Symptoms
- Warning light and stored transmission fault
- Neutral or drive selection restricted
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P27F2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.