P27F1
Transmission Range Control B Position Sensor/Switch Circuit Low
P27F1 reports a valve B position signal that has collapsed toward ground in GM's internal range selection. GM describes the trigger as a ground short or open circuit on the mode valve B sensor line and uses the same 0.414 V limit, 0.100 s debounce and 9 V minimum supply as on valve A; both table editions, 2018 and 2020, rate it Type A, MIL on the first trip. As long as P27F1 is active, the TCM cannot verify valve B and drops its movement test P27F0. Hall sensors need a supply and a ground, so a dead supply pin also produces a low reading. Typical repairs concern the internal harness, the pass-through seal or the sensor. Valve A's counterpart is P27ED; high is P27F2.
Possible causes
- Valve B sensor line shorted to ground high
- Sensor supply missing at the internal connector medium
- Hall sensor on mode valve B failed medium
Symptoms
- MIL comes on on the first trip
- Neutral or drive engagement slow or blocked
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P27F1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.