OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27EF

Transmission Range Control B Position Sensor/Switch Circuit/Open

P27EF concerns the second mode valve, B, of GM's internal electronic range selection. Its Hall sensor is expected to sit clearly high or clearly low; GM's 2018 9-speed and 2020 10-speed RWD tables treat a raw value between 1.263 and 1.504 V, held for 0.100 s of a 0.163 s sample, as an illegal level. A level in that gap typically comes from an interrupted signal line or a sensor that has stopped switching. The tables show the same timing as for valve A, but the MIL column for P27EF is left blank in both editions, so the illumination type is not stated. Mode valve B is involved in neutral and drive states, so shifting may be limited. Low and high are P27F1 and P27F2, the movement test P27F0.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / EF

Possible causes

  • Mode valve B sensor signal line interrupted high
  • Hall sensor on mode valve B no longer switching cleanly medium
  • Fluid or corrosion at the transmission pass-through connector medium

Symptoms

  • Transmission warning, neutral or drive engagement may be restricted
  • Fault stored in the TCM

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P27EF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication