OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27EE

Transmission Range Control A Position Sensor/Switch Circuit High

The opposite of P27ED: the position sensor of mode valve A reads higher than any valid state. GM's TCM tables for the T87A nine-speed of 2018 and the rear-drive ten-speed of 2020 set P27EE when the raw signal exceeds 2.538 V for 0.100 s inside a 0.163 s sample, describing it as a short to voltage on the sensor circuit; the MIL comes on at once (Type A). A sensor that has lost its ground return can also float upward and mimic a short. While the fault is present, GM blocks the plausibility test P27EC and several pressure checks, since the valve position is unknown. Repairs usually involve the internal harness or the sensor; valve B reports the same condition as P27F2, the open band as P27EB.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / EE

Possible causes

  • Sensor signal shorted to a voltage source high
  • Sensor ground open, signal drifts high medium
  • Hall sensor output stage faulty low

Symptoms

  • MIL on from the first trip
  • Range changes restricted, possible reduced mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P27EE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication