P27ED
Transmission Range Control A Position Sensor/Switch Circuit Low
P27ED tells that the Hall sensor on mode valve A of GM's internal range selection delivers almost no voltage. In both the 2018 9-speed and the 2020 10-speed RWD tables the limit is a raw value under 0.414 V for 0.100 s within 0.163 s, with at least 9 V on the battery; GM itself blames a grounded or interrupted line. The code is Type A and lights the MIL on the first trip. Because the TCM then cannot confirm whether the valve has left park, the movement check P27EC is suspended while P27ED is active. Look at the sensor connector inside the transmission and the pass-through plug. High is P27EE, the invalid middle band P27EB, and valve B uses P27F1 for the same fault.
Possible causes
- Sensor signal shorted to ground in the internal harness high
- Sensor supply open, output collapses medium
- Hall sensor on mode valve A failed medium
Symptoms
- MIL lit immediately
- Shifts out of park slow or blocked
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P27ED
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.