OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27EC

Transmission Range Control A Position Sensor/Switch Circuit Range/Performance

P27EC is GM's movement check for mode valve A of its internal range selection: after the TCM commands park, drive or reverse, the position sensor must report the new state within a set delay; the logic also watches line pressure and clutch slip. Both the 2018 nine-speed and 2020 ten-speed tables rate it Type A. Bulletins show it is often hydraulic: 21-NA-169 has the valve body replaced on low-mileage 9T45/50/60 units when P27EC or P27F0 appear with clean fluid, PIP6069 says to renew the valve body rather than the TCM on 2024 full-size trucks and SUVs with the 10L80, and 19-NA-200 notes that on the 2025 Equinox a failed auxiliary pump or harness sets P27EC before P2797.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / EC

Possible causes

  • Mode valve A sticking inside the control valve body high
  • No hydraulic pressure from a failed auxiliary pump during auto stop medium
  • Mode valve A position sensor reading wrong low

Symptoms

  • Delayed or refused shift into park, drive or reverse
  • MIL on, stop-start may be disabled
  • Transmission in reduced operating mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P27EC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication