P27E6
Electric/Auxiliary Transmission Fluid Pump Control Valve Circuit High
P27E6 means the control valve circuit of the auxiliary pump reads higher than allowed, as if the line were tied to battery voltage. A wire rubbing against a live conductor in the same harness, or a driver stage that no longer switches off, are the classic triggers. The code is not documented by any manufacturer in public. As a model of the hardware, VW's 0GC and 09P training books describe an electric pump V475 whose oil is steered by a pressure-regulated changeover valve; a permanently energized drive would hold that valve in one position. CARB 13 CCR 1968.2 calls for detecting such shorts. Because the valve cannot be released, the module typically disables stop-start. Low is P27E5, open circuit P27E3.
Possible causes
- Control line shorted to a supply wire in the harness high
- Output stage in the control module stuck on low
- Corrosion bridging adjacent pins in the connector medium
Symptoms
- Stop-start inoperative
- Warning light on, possibly further pump codes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27E6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.