P27E5
Electric/Auxiliary Transmission Fluid Pump Control Valve Circuit Low
P27E5 sets when the voltage on the auxiliary pump control valve line is pulled toward ground, typically by chafed insulation touching the case or by a coil shorted internally. No manufacturer documents the code openly. For orientation: in Volkswagen's 8-speed 09P and 0GC transmissions the electric pump V475 keeps pressure while the engine is stopped, and a regulator-driven valve routes its flow; a grounded drive line would leave that valve in its spring position. CARB 13 CCR 1968.2 requires circuit monitoring for such outputs. The controller usually switches the output off to protect its driver. P27E6 is the opposite fault, a short to supply; P27E3 an open. Check the harness where it passes brackets or the oil pan.
Possible causes
- Control line chafed through and touching ground high
- Valve coil shorted internally medium
- Fluid or water in the connector bridging to ground low
Symptoms
- Stop-start switched off
- MIL lit
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27E5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.