P27E4
Electric/Auxiliary Transmission Fluid Pump Control Valve Circuit Range/Performance
P27E4 is the plausibility check for the auxiliary pump control valve: the circuit is intact, but its current or its hydraulic effect does not match the command. No manufacturer lists the code publicly, so the logic can only be inferred. In a layout like Volkswagen's 0GC dual-clutch box, where a pressure regulator moves a changeover piston to steer the oil of the electric pump, a sticking piston or a coil with drifting resistance would cause exactly this mismatch. CARB 13 CCR 1968.2 asks for both electrical and functional monitoring of transmission actuators. Dirty fluid and varnish are the usual reasons a valve hangs. Unlike P27E3, P27E5 or P27E6 the wiring tests pass here; P27E1 may follow if pressure stays too low.
Possible causes
- Valve or changeover piston sticking from contaminated fluid high
- Coil resistance drifting with temperature medium
- Contact resistance at the connector distorting the current low
Symptoms
- Stop-start works only sometimes
- Harsh engagement after an auto-start
- Warning light on
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P27E4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.