P27E3
Electric/Auxiliary Transmission Fluid Pump Control Valve Circuit/Open
The control valve named here decides where the oil from the electric auxiliary pump goes. Volkswagen's training book for the 0GC seven-speed DSG shows such a layout: pressure regulator N218 shifts a spring-loaded changeover piston that sends the flow of pump V475 either to the mechatronic unit or to clutch cooling. No maker publishes P27E3 itself. The code reports that the valve's drive circuit is broken or so resistive that the module measures no proper current: a cut wire, a lifted pin or an open coil. Without the valve the pump flow can end up in the wrong branch, so stop-start or cooling support may be dropped. P27E5 and P27E6 cover shorts, P27E4 a valve that responds wrongly.
Possible causes
- Broken conductor in the valve control line high
- Pin backed out or corroded at the gearbox connector medium
- Valve coil burnt open medium
Symptoms
- Stop-start unavailable
- Warning light with stored open-circuit fault
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27E3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.