P27E2
Electric/Auxiliary Transmission Fluid Pump B Pressure Too Low
P27E2 flags that the second electric pump, B, delivered too little pressure although it was driven. Nobody publishes this code openly. Where a gearbox carries a pump labelled B, it is often a separate unit on the outside of the case: Audi's bulletin 34-17-25 calls oil pump V553 of the 0CJ, 0CK and 0CL seven-speed twin-clutch boxes pump B and lists P27A3, P27A6 and P276B for it, but not P27E2. CARB 13 CCR 1968.2 requires such actuators to be checked for proper function. Compared with P27A3, which covers no delivery at all, P27E2 points to a pump that works but weakly; P277A singles out hydraulic leakage, P27E1 is the same check on pump A. Expect stop-start or clutch cooling to be restricted.
Possible causes
- Pump B worn, motor running but delivering too little high
- Leaking O-ring or pressure line between pump B and the gearbox medium
- Fluid level too low for pump B to prime medium
- Weak battery or poor ground slowing the pump motor low
Symptoms
- Stop-start no longer stops the engine
- Reduced clutch cooling, power limited when hot
- Warning light on
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P27E2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.