OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27E1

Electric/Auxiliary Transmission Fluid Pump A Pressure Too Low

P27E1 is a hydraulic verdict, not a wiring one: electric auxiliary pump A was running on command, yet the pressure it built stayed below what the module expected. No manufacturer documents this exact code publicly. GM shows how such a check works on its CVTs (2025 TCM tables): during an engine auto-start, with more than 400 kPa requested, both pulley pressure sensors reading under 200 kPa for over 0.525 s set the broader performance code P2797, Type B. Wiring faults on the pump belong to P2796 and its siblings, leakage to P0B0C, and pump B has P27E2. Worn pump gears, a clogged intake screen, low fluid or a leaking check valve are typical. Stop-start is usually blocked, and restarts after a stop may engage harshly.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / E1

Possible causes

  • Worn pump gears or internal leakage inside pump A high
  • Low or aerated transmission fluid, pump draws air medium
  • Intake screen of the pump partly blocked by debris medium
  • Check valve in the pump circuit not sealing low

Symptoms

  • Stop-start function disabled
  • Jerky or delayed engagement when the engine restarts after a stop
  • MIL or transmission warning lit

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P27E1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication