P27DF
Pressure Control Solenoid T Control Circuit Low
P27DF points to a control line of solenoid T pulled too low. In Ford's 2024 OBD summary it is the shorted-switch fault of the selector pilot valve on the TR9070 dual-clutch gearbox, meaning the switched side of the coil is tied to ground and the valve can be powered permanently. Ford publishes no thresholds. GM's equivalent test on the Corvette selector pilot valve (P282F in 23OBDG07) flags a sense voltage below roughly 1.7 V for 100 ms while the output is on. A permanently applied pilot valve holds the selector in its working position, so the shift valves keep acting on the same rods and the controller has to fence off gears. Inspect for insulation damage and a coil shorted to ground.
Possible causes
- Damaged insulation letting the wire touch ground high
- Solenoid T coil shorted to ground medium
- TCM output switch stuck conducting low
Symptoms
- MIL on
- Gears fenced off, shifts limited to some gears
- Limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27DF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.