P27DA
Pressure Control Solenoid T Stuck On
P27DA marks solenoid T as delivering pressure while it should be vented. Ford lists it in the 2024 overview for the TR9070 for a selector pilot valve whose hydraulic output stays on; neighbouring entries P178C and P178A cover the selector valve and the complete selector mechanism stuck on. Ford gives no detection limits. For comparison, GM detects the same fault on the Corvette selector pilot valve (code P282A, 23OBDG07) during a synchronizer integrity routine: small test movements of the rods show whether the selector sits in the opposite position to the one commanded, and a current-profile check of the pilot valve separates it from the selector spool. A selector locked in one position sends shifts to the wrong rods, so the TCM blocks gears.
Possible causes
- Selector pilot valve held open by dirt high
- Worn seat or armature in solenoid T medium
- Abrasion particles from clutch or synchronizer wear low
Symptoms
- MIL on
- Gears locked out, wrong gear engagement possible
- Fallback mode
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27DA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.