P27D7
Pressure Control Solenoid S Control Circuit Low
P27D7 reports the control line of solenoid S stuck at too low a level, typically a short to ground. GM applies it to synchronizer actuation valve 5 on the Corvette dual-clutch gearbox (23OBDG07, carried into 24OBDG07): with the output switched on, the sense pin should be pulled down only partly; if it drops below roughly 1.7 V and stays there 150 ms, the driver chip flags a ground short and the TCM stores a Type A fault. As the coil is switched on the ground side, a grounded line can leave valve 5 powered without command, pushing rod 5 against the intended gear. Ford's TR9070 does not use solenoid S. Look for chafed insulation near brackets and for a coil shorted to its housing.
Possible causes
- Control wire chafed through to ground high
- Solenoid S coil shorted to its housing medium
- Faulty low-side driver in the TCM low
Symptoms
- MIL on
- Unintended rod 5 movement, gears locked
- Limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27D7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.