P27D6
Pressure Control Solenoid S Control Circuit Range/Performance
P27D6 would indicate that the circuit of solenoid S is still closed but its electrical behaviour does not fit what the module commands. There is no public manufacturer description. On the Corvette dual-clutch transmission GM does compare target and estimated coil current of valve 5 (a 70 % gap held 60 ms, or a 400 mA gap held 300 ms, per 23OBDG07), yet files that result under the high-circuit code P27D8, so P27D6 stays unused there. CARB 13 CCR 1968.2 only sets the general duty to check actuator circuits. If another controller stores it, likely culprits are added resistance at a crimp, a coil whose ohms have drifted with age and heat, or a TCM output stage losing strength.
Possible causes
- Added resistance at a crimp or pin high
- Solenoid S coil resistance out of specification medium
- TCM output stage losing strength low
Symptoms
- MIL on
- Uneven shifts into rod 5 gears
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27D6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.