P27D5
Pressure Control Solenoid S Control Circuit/Open
P27D5 stands for an interrupted control circuit of solenoid S. GM uses it for synchronizer actuation valve 5 in the Corvette DCT, documented in 23OBDG07 and again in 24OBDG07. While the low-side output is off, a working coil pulls the sense pin up to supply voltage; the driver chip then tries to hold that pin low with a tiny current. If it manages to, the pin settles at roughly 1.7 V to 3 V, and after 150 ms this counts as open load, Type A with MIL. The test only runs between 8.75 and 18 V supply, not during cranking, and is suppressed when P0882 or P0883 is present. Ford's TR9070 has no valve S. With valve 5 dead, rod 5 cannot be moved and its gears drop out.
Possible causes
- Terminal pushed back in the gearbox connector high
- Open winding in solenoid S medium
- Broken control wire between TCM and valve medium
Symptoms
- MIL on
- Gears on rod 5 missing
- Emergency program
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27D5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.