P27D4
Pressure Control Solenoid S Intermittent
P27D4 means the controller noticed solenoid S dropping out now and then, electrically or in its effect, without the fault staying present. No manufacturer publishes this code. GM, whose Corvette dual-clutch gearbox has a fifth synchronizer valve for rod 5 (tables 23OBDG07 and 24OBDG07), reports lasting wiring faults on it as P27D5, P27D7 and P27D8 and its stuck states as P27D1 and P27D2; a separate sporadic code is not listed there. CARB 13 CCR 1968.2 still requires transmission actuators to be monitored. For the driver it can mean an occasional refusal of the rod 5 gears. Wiggle-test the harness with the engine running, inspect the gearbox connector seal and check whether the fault follows heat.
Possible causes
- Gearbox connector seal leaking, terminals corroding high
- Harness conductor breaking under engine movement medium
- Solenoid S winding dropping out when hot low
Symptoms
- MIL comes and goes
- Rod 5 gears occasionally refused
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.